A Guide To Home Insulation Materials

Dated: 01/05/2019

Views: 189

A Guide to Home Insulation Materials

Insulation is one of those building products that you never see, because it is usually covered up by something else. But if you don't have enough, or if it is installed incorrectly, you're wasting energy and paying more for heating and cooling than is necessary.

There are a number of insulation products you can use to prevent energy loss. However, it is important to realize that insulation is only one part of a two-prong approach to energy efficiency. The other arm of the plan involves sealing all of the holes, cracks or openings caused by pipes, wires, chimneys or anything that creates an opening in a wall, ceiling, or most importantly, attic floor.

These openings allow interior air to escape to the unconditioned (not heated or cooled) space that surrounds your home. The sealing process is called "air sealing," and requires silicone caulk and expanding foam that comes in a can. It isn't exciting work, and while easy, it requires attention to detail. It is extremely important because the openings are escape routes for heated and cooled air and because many insulation products do not stop moving air. If you plan on insulating, be sure to attend to air sealing as well.

Where to Insulate

Basically, insulation should be placed in any area that separates your heated and cooled living spaces from areas that are not heated and cooled. These areas include:

  • • Attics

  • • Cathedral ceilings

  • • Sidewalls

  • • Walls between the living area and an attached garage

  • • Floors over unheated basements

  • • Floors over crawl spaces

  • • Foundation walls

Insulation Materials

The effectiveness of insulation is measured by its R-value - "R" stands for resistance to heat flow. The higher the R-value, the better. It is important to match the insulation to the application as well. For example, fiberglass insulation has an R-value of about 2.8 to four per inch. Some foam panels have R-values of seven or eight. But you can easily find fiberglass batts or blankets that are 12 inches thick and designed for use as attic insulation, providing over an R-40. Standard foam panels only come in one-half to two inch thicknesses.

Some products are easier to install than others. Fiberglass batts simply roll into place. They are manufactured to fit snugly between ceiling joists and wall studs. When installing any insulation, it is important that the product be placed flat against the surface you are insulating. Any air space under the insulation or gaps around the edges will limit the effectiveness of the product.

Here's a look at some common insulation products:

Type of Insulation R-Value per Inch Where It’s Installed Notes
Fiberglass

Mineral Wool
(Available in batts, blankets and as a loose fill material)
2.8 to 4
  • Attics

  • Open wall stud cavities

  • Floors over unheated spaces

  • Batts and blankets are DIY projects

  • Loose fill is a professional installation

  • Compressing the insulation or getting it wet reduces R-value

Cellulose 3 to 3.7
  • Attics

  • Open wall

  • cavities

  • Closed wall cavities

  • Hard-to-reach areas

  • Cellulose is ground- up paper treated with fire retardants

  • Blown-in with special equipment

  • Can be poured in place

  • Even distribution is necessary for effectiveness

Foam Boards
  • Polystyrene: 4 to 5

  • Polyisocyanurate / polyurethane: 6 to 8

  • Foundation walls

  • Interior basement walls

  • Floors

  • Ceilings

  • Interior applications must be covered with drywall for fire safety

  • Used for air sealing large openings

  • Some types are used under exterior siding to enhance the R value of the wall and prevent heat transfer through framing members

Spray-On Polyurethane
  • Open-cell: 3.6 to 4.3

  • Closed-cell: 5.6 to 6.8

  • Open and enclosed wall cavities

  • Between rafters on cathedral ceilings

  • Hard to reach areas

  • Irregularly shaped areas

  • Requires special application equipment

  • Closed-cell material is denser and acts as a vapor barrier

  • Both act as an air barrier

Use this chart as a reference point when insulating your home. Proper insulation will help lower your energy bills and keep your home at a comfortable temperature.



Blog author image

Stacey Grant Williams

My name is Stacey Grant-Williams! I am a proud military wife and a Preferred Real Estate Brokers realtor in Central Florida specializing in Celebration, Altamonte Springs, Clermont, Davenport, Haines ....

Want to Advertise on this Site?

Latest Blog Posts

A Guide To Home Insulation Materials

Insulation is one of those building products that you never see, because it is usually covered up by something else. But if you don't have enough, or if it is installed incorrectly, you're wasting

Read More

STOP RENTING FIRST TIME HOME BUY WITH NO MONEY DOWN WITH GOOD CREDIT

RENTERSStop Paying YourLandlord'sMortgage.Free Report reveals HowEasy it is to BuyYour Own Home.Free recorded message1-844-877-8814ID# 1001TEXT ME AT 321-231-8487his new one story home features an

Read More

HOW TO SELL YOUR HOME WITH OUT AN AGENT

How to Sell Your Central Florida HouseWithout An Agent And Save theCommissionCentral-Fl - If you've tried to sell your homeyourself, you know that the minute you put the "ForSale by Owner" sign

Read More

For Sale By Owner Home Without An Agent You May Not Know The Questions To Ask To Stay Safe

Buyers need to keep a few things in mind. An exceptional buyer’s agent represents your best interests. The agent owes the buyer undivided loyalty, confidentiality, reasonable care, obedience to

Read More